Scraper chain conveyor is mainly used to transport non viscous loose, granular, and small materials, and is a fixed conveyor equipment. The height of the chain plate edge guard is generally 80-120mm, and can be adjusted appropriately according to the conveyed materials and conveying volume during design. The angle is generally not more than 15 ° to prevent excessive material leakage. The power device is located at the head of the chain plate machine, and the assembly form can be changed according to user requirements. The appropriate conveying speed is 8-10m/min.
Installation of scraper chain conveyor:
Install the frame of the scraper chain conveyor, starting from the head frame, then sequentially installing the middle frame of each section, and finally installing the tail frame. Before installing the rack, the center line must be drawn along the entire length of the conveyor. Maintaining the center line of the scraper chain conveyor plant in a straight line is an important condition for the normal operation of the conveyor belt. Therefore, when installing each section of the rack, it is necessary to align with the center line and also level the rack. The allowable error of the rack to the center line is ± 0.1mm per meter of machine length. However, the error in the center of the frame over the entire length of the conveyor shall not exceed 35mm. After all individual sections are installed and aligned, they can be connected together.
