The working surface of the chain scraper conveyor should be kept straight. If the work surface is not straight, the tension of the two chains will be different, which will cause uneven wear of the chain or cause the bottom chain to fall, jam, or break. The bending of the chain scraper conveyor should be appropriate. Don't appear "rapidly bent". The bent part should be no less than 8 chute. When moving, pay attention to the cooperation of the front and rear hydraulic jacks to avoid sharp bending. Otherwise, it will cause the chutes to stagger and cause the chain to break. Special attention must be paid to the fact that the scraper conveyor cannot move when it is stopped.
The chain scraper conveyor should be flat. Due to the limitation of the chute structure, it can only adapt to changes in the vertical direction. Therefore, if the surface portion of the work surface is uneven, the flattening of the chain scraper conveyor facilitates the operation of the scraper chain, and the chute can be reduced. Wear and reduce power consumption.
During blasting, the transmission parts and pipes of the chain scraper conveyor, unit cables, switches, etc. must be protected. When the chain scraper conveyor is transporting iron and long materials, safety measures should be taken to avoid personal accidents. The overlap between the tail of the transition groove and the middle groove does not allow excessive bending. When bending is applied, a wooden board is used. Pay particular attention to the vibration of the coupling. Check the vibration of the hydraulic coupling when the scraper conveyor is started. To protect good heat dissipation conditions, the protective cover and liquid should be cleaned frequently.
