Conveyor belt scraper mining machinery and equipment is essential for coal mine production, and the management and maintenance of equipment is strengthened during the use to ensure the normal operation of coal mine production. Due to the special nature of coal mine production, the requirements for safe production are very high. This article shares the maintenance and repair of conveyor belt scraper.
1. Preparation before starting up
When the conveyor belt scraper is turned on, it should be fully prepared before starting the machine. It should be strictly checked the safe operating environment of the power transmission system, clean the surrounding environment, ensure that there is no messy dirt, the pipeline is neat, and the mechanical equipment Whether some of the protection devices are in a normal protection state, the tightness of the tape should be strictly notified to prevent various failures during operation.
2. Strict observation during operation
During the operation of the conveyor belt scraper, the corresponding start signal should be issued before starting the machine. After the confirmation response is received, the start-up can be started. After the start-up, the operator should also strictly observe the various sound signals emitted by the mechanical equipment after the start-up. Make sure that the tape runs smoothly. If there is a deviation in the position of the tape during operation, it should be handled in a timely manner.
3. Preventive measures and precautions
(1) The conveyor belt scraper is normally started when there is no load, and stops after the material is discharged.
(2) When a person works above the belt or repairs the belt, the power must be turned off and locked.
(3) The operator should stop and lock when leaving the scraper conveyor, and the guardrail at the rear of the belt conveyor must be placed on the side.
